EasyDCC Plug-In Throttle BUS Components

Fascia Plate This plate is provides two side-by-side sockets in which to plug your walk-around throttles. Interconnecting the fascia plates is done with inexpensive, readily available coax cable and twist-on plugs. The Fascia Plate is available either fully assembled or as a kit. Each contains a pre-punched and painted metal face plate, the circuit board, two F-type jacks, two headphone sockets and two twist-on coaxial cable plugs. If building the kit, only simple soldering is needed and takes about 5 minutes. No special tools are needed for assembly. The metal faceplate can also be purchased separately. Part#       Description EDFA........Assembled Fascia Plate Kit EDFK........Unassembled Fascia Plate Kit DCFP........Face Plate Alone Return to top

Throttle Bus Extender Board This little circuit board drives your throttle bus and is called an "Extender." It is designed to mount under the layout near the Command Station. Use multiple Extenders for large layouts. The Basic Extended Starter System includes this board, its transformer and a modular cable to connect back to the Command Station. There is no limit to the number of extenders that may be used. More Extenders can be added to the Command Station to connect additional wireless receivers or if more than 10 plug-in walk-around throttles are to be used. Each Extender comes with a 7 foot modular cable and a twist-on coax cable plug. Part#       Description EDXA........Extender [requires 12vnt transformer below] Return to top

Extender Transformer The 20VA transformer - 12VAC @1A - has plenty of power for your throttle-bus Extender circuit board. One transformer can be shared with another Extender circuit board. Screw terminals make for quick hookup. For use in the Americas and Japan only. Plugs into any 110VAC outlet. Output wires are stripped and tinned and about 72 inches in length. Primary is protected with internal fuse. Energy Star Level-IV and ROHS compliant. Part#       Description 12vnt.......Extender Transformer Return to top

Plugs and Jacks The throttle bus cable is nothing more than inexpensive TV "RG59-coax" cable and connects all the fascia plates to the Extender. Coax cable is readily available at stores such as Radio Shack. Be sure to obtain copper braided coax since it works much better with the twist-on plugs. Connecting the coax to the fascia plate is done with "twist-on" connectors also called plugs. Each fascia kit contains two plugs. After stripping the coax cable, these connectors simply screw on to the cable. No special tools or soldering required. The F-jack is mounted on the fascia plate circuit board. Two come with each fascia plate kit. There is room for one more optional jack if needed. Part#       Description PLUG........Twist On Plug JACK........PCB mount Jack Prices do not include shipping or handling. All prices subject to change without notice. Return to top

© CVP Products | Click Link           All Rights Reserved | Trademarks       Click Link P.O. Box 831333 · Richardson, TX 75083-1333 Phone: 972.238.9966 email: info@cvpusa.com · www.cvpusa.com